Disassembling Kodak Advantix F350 Back Cover
David Cottrell and 7 other contributors
Last updated on Dec 4, 2014
Views: 1.8K
View statistics:
- Past 24 Hours:
- 3
- Past 7 Days:
- 17
- Past 30 Days:
- 97
- All Time:
- 1,793
Comments: 0
No one has left comments on this guide. Will you be first?
Go to guide commentsCompleted: 1 2
1 person has marked this guide "completed." Will you be next?
2 people have marked this guide "completed." Including you — great job!
Favorites: 0 1
No one has favorited (and subscribed to) this guide. Will you be the first?
1 person has favorited (and subscribed to) this guide — and that's you!
Better Introduction
Improve this guide by completing or revising its introduction.
What you need
Tools
-
-
-
Turn off the camera.
-
Locate the power switch on the front of the camera below the camera lens.
-
Slide the switch to the off position.
Ask FixBot
-
-
-
Locate the 3 screws that hold the back cover to the camera.
-
One screw is located on the film opener side of the camera.
-
The other screws are located on the opposite side of the camera.
-
-
-
Use the Phillips #00 Precision Screwdriver and remove the screws on the back cover.
-
-
-
Open the film door to remove the back cover.
-
Slide the film door lever to the left until the film door opens.
-
-
-
-
Use a plastic opening tool to pry the case open until a small gap is present.
-
Repeat this process at the top and bottom of the film door to loosen it.
-
-
-
Grab the top and bottom of the case firmly as shown.
-
Gently remove the back of the camera case with a slight twisting motion.
-
-
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Team
UW Stout, Team 1-2, Zhou Fall 2011 Member of UW Stout, Team 1-2, Zhou Fall 2011
UWSTOUT-ZHOU-F11S1G2
4 Members
60 Guides authored
