Introduction
Use this guide to remove the back plate on your IINE Retro Pocket game controller.
What you need
-
-
Set the controller down on your working surface.
-
Flip the controller over so the back of the controller is facing up, with the shoulder buttons facing away from you.
-
Use a Phillips #1 screwdriver to remove the four black 7.5mm screws from the corners of the back plate.
Ask FixBot
-
-
-
-
Use the tip of an opening pick to separate the back plate. Start at the bottom corner, and pry downwards.
-
As you make your way toward the center, you will eventually disengage the retaining clips located on either side of the status LED array.
-
Lift the back plate up and away from you, and set it aside.
-
-
-
Once the back plate is removed, you now have access to the internals of the controller.
-
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
