Introduction
Use this guide to remove the camera lens piece.
What you need
-
-
-
Remove 2 screws from each side of the camera (4 total, 0.102 in).
-
Remove 2 screws from the bottom on the camera (0.138 in).
-
-
-
-
Remove the top-left screw above the LCD screen (0.100 in).
-
Remove the C-shaped plate from the side of the LCD screen.
-
-
-
Remove the screw from the top-right of the LCD screen (0.098 in).
-
Remove the L-shaped bar from the right of the LCD screen.
-
-
-
Use the spudger to remove the L-shaped bar from the left-side of the LCD screen.
-
-
-
Tool used on this step:Tweezers$4.99
-
Use tweezers to remove the connector ribbon from the top-left corner above the LCD screen.
-
-
-
Use a spudger to lift the connector lock (black flap) at the end of the larger LCD connector ribbon on the front side of the camera.
-
Use the tweezers to lift this ribbon.
-
Use the tweezers to gently peel this ribbon from the one underneath it.
-
-
-
-
-
Remove the screw located on the side of the camera (0.072 in).
-
-
-
Use the spudger to remove the lens ribbon from the circuit board.
-
Use the spudger to lift the ribbon.
-
-
-
Remove the flash assembly, which includes the capacitor. If it resists, note the small hook on the right side near the bottom.
-
-
-
-
-
Use spudger to carefully lift the LED light off the upper-left corner of the lens.
-
Ask FixBot
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
19 other people completed this guide.
Team
Cal Poly, Team 3-32, Regan Winter 2011 Member of Cal Poly, Team 3-32, Regan Winter 2011
CPSU-REGAN-W11S3G32
3 Members
96 Guides authored
