Disassembling 8BitDo SN30 Pro Controller Gamepad disassebly

Screws List:

4 x "Torx 6" 7mm screws

6 x "Phillips 1" 10mm screws

10 x "Phillips 1" 5mm screws

1. Open the back lid

2. Remove battery

Remove 4 screws:

2 screws in handles

2 screws under the label

3. Unclip trigger's covers

JFYI: My label is not original

Using pry tool to split two parts. Start from handles.

Open to the right carefully - there is a ribbon cable

Slide ribbon cable lock to the right, then unplug ribbon cable

Remove 9 x "Phillips 1" 5mm screws

Remove stick caps

Eject vibration motors from slots in handles

Eject circuit board

Remove 6 x "Torx 6" 10mm screws

Remove 1 x "Phillips 1" 5mm screw

Remove circuitboard with plastic attachments

Deattach buttons, rubber pads and plastics aligners.

While assembling back, make sure, ABXY rubber pad cut angle is on top.

Unclip plasctic attachments with buttons and triggers. They are connected by pressure alone to the PCB

PCB with sticks and vibration motors alone