Free Shipping on Domestic Orders $75+

Introduction

This guide will be showing you how to replace the 3.7V battery in the back of the tablet. Be sure to carefully remove the battery from the back of the screen and do not puncture it.

Battery information:

- JZ Li-ion PL28106110

+ 3.7V 3100MAH 1406

What you need

Step 1 Battery

Digital2 D2-861G Battery Replacement, Battery: step 1, image 1 of 1

Working on your device while powered on may result in electric shock. Make sure to unplug and power down your device before you begin.
Place your device on a soft cloth to avoid scratching the screen.
Flip your device over so back panel is facing upwards

Edit

Step 2

Do not use a lot of force as it can break the clips or the back panel.
Insert spudger in the slot below the micro SD card
You should hear clips releasing as you pry along the edges.
With the spudger tool, run along the edges of the backing undoing 20 plastic clips.

Edit

Step 3

Digital2 D2-861G Battery Replacement: step 3, image 3 of 3

Look at the images to locate the black tabs.
Carefully remove the tape to avoid damaging the device.
Remove ALL the yellow tape securing the gold colored ZIF (Zero insertion force) connector and the battery. Discard or save the tape if you would like.
To unclip the connector. Go under the black tab with a spudger or finger nail and simply lift up.

Edit

Step 4

Make sure to not bend or puncture the battery when removing it.
Locate the bundled cable connector and disconnect it by simply pulling it gently with your hands or using a spudger.
Use prying tools to carefully break the adhesive under the battery