DigiTech RP70 Amp/Mixer Switch Replacement
Elijah Smith and 3 other contributors
Last updated on Jan 2, 2019
Views: 704
View statistics:
- Past 24 Hours:
- 2
- Past 7 Days:
- 9
- Past 30 Days:
- 66
- All Time:
- 704
Comments: 0
No one has left comments on this guide. Will you be first?
Go to guide commentsCompleted: 0 1
No one has marked this guide "completed." Will you be the first?
1 person has marked this guide "completed." It's you — great job!
Favorites: 0 1
No one has favorited (and subscribed to) this guide. Will you be the first?
1 person has favorited (and subscribed to) this guide — and that's you!
Introduction
Go to step 1 ↓If the amp/mixer switch is broken this guide will teach you how to remove the broken component for replacement.
What you need
Tools
-
-
-
Remove the four 8mm Phillips #0 screws located on the back panel.
Ask FixBot
-
-
-
Remove the two 11mm #0 Phillips screws located at the bottom of the motherboard.
-
-
-
Lift the indented end of the motherboard opposite the input/output jacks. Then, pull away from the input/output jacks to slide the motherboard out of the casing.
-
-
-
-
-
-
Desolder the back of the motherboard where you want to replace the switch.
-
-
To reassemble your device, follow these instructions in reverse order.
Team
Appalachian State University, Team S2-G2, Menagarishvili Fall 2018 Member of Appalachian State University, Team S2-G2, Menagarishvili Fall 2018
APSU-MENAGARISHVILI-F18S2G2
3 Members
72 Guides authored
