Introduction
Follow these steps in order to successfully replace the SSD of your laptop.
What you need
-
-
Use PH0 screwdriver to unscrew the 4.49x7.88 mm screw in the middle of the back panel.
Ask FixBot
-
-
-
Place thumbs flat on the front side of the back panel (the side to open the laptop).
-
Push panel upwards sliding it out of the locked position.
-
Lift panel out of socket.
-
-
-
-
Remove panel and screw from the device. This opens up the main board of the device.
-
-
-
Using your finger and thumb lift the hard drive out of the computer but do not disconnect the attached connector to the computer.
-
-
-
By applying pressure to the sides of the connector, pull the connector apart from the SSD.
-
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
6 other people completed this guide.
Team
Baylor, Team 5-6, Williams Spring 2015 Member of Baylor, Team 5-6, Williams Spring 2015
BU-WILLIAMS-S15S5G6
4 Members
6 Guides authored
1 Guide Comment
You can use any mSATA SSD as replacement by using the following caddy/adapter:
