Free Shipping on Domestic Orders $75+

Introduction

This guide gives directions on how to replace the two internal drivers located in the DeWalt Jobsite DCR010. Replacing these drivers will bring new life to your device if you've noticed poor or no sound quality.
This guide is fairly simple and will only involve removing screws and disconnecting electrical connections.

What you need

Step 1 Case

DeWalt Jobsite DCR010 Drivers Replacement, Case: step 1, image 1 of 3

DeWalt Jobsite DCR010 Drivers Replacement, Case: step 1, image 2 of 3

DeWalt Jobsite DCR010 Drivers Replacement, Case: step 1, image 3 of 3

Remove the eleven 15 mm screws on the corners and back of the device casing using a Phillips #2 screwdriver.
If you're using the iFixit tool kit, you may need to utilize the 4 mm nut driver as an extension in order to reach the deep screws on the backside of the case.

Edit

Ask FixBot

Step 2

Take the casing apart by pulling the rubber corners away from the body of the speaker.
Pull the top handle away from the body of the case once the corners are removed.

Edit

Ask FixBot

Step 3

DeWalt Jobsite DCR010 Drivers Replacement: step 3, image 3 of 3

Remove or slice the DeWalt sticker on the left side of the device in.
Push out the two pins on the top of the device.
You may need to pry at the bottom of the device, if so, use an opening tool.

Edit

Ask FixBot

Step 4

Unplug the connections running between the two sides of the case by pinching the tab on the non-speaker side and pulling away from the point of attachment.

Edit

Ask FixBot

Step 5 Drivers

DeWalt Jobsite DCR010 Drivers Replacement, Drivers: step 5, image 1 of 1

Remove the eight 10 mm screws holding the drivers to the chassis with a Phillips #2 screwdriver.
If you are having trouble moving around the center tube, it can be removed by unscrewing the four 15 mm screws using the Phillips #2 screwdriver.

Edit

Ask FixBot

Step 6

Remove the speakers from the device.
Take note of the pin marked as with the red square in the photo. You'll need to be sure the pin is aligned with the bracket on the speaker when it comes time to reinstall.

Edit

Ask FixBot

Conclusion

To reassemble your device, follow the above steps in reverse order.
Take your e-waste to an R2 or e-Stewards certified recycler.
Repair didn’t go as planned? Try some basic troubleshooting or ask our Answers community for help.

Cancel: I did not complete this guide.