DeWalt DCS380 Grip Disassembly
Jonathan Hicks and 2 other contributors
Last updated on Oct 31, 2019
Views: 878
View statistics:
- Past 24 Hours:
- 1
- Past 7 Days:
- 10
- Past 30 Days:
- 54
- All Time:
- 878
Comments: 0
No one has left comments on this guide. Will you be first?
Go to guide commentsCompleted: 0 1
No one has marked this guide "completed." Will you be the first?
1 person has marked this guide "completed." It's you — great job!
Favorites: 0 1
No one has favorited (and subscribed to) this guide. Will you be the first?
1 person has favorited (and subscribed to) this guide — and that's you!
Introduction
Go to step 1 ↓This guide will show how to disassemble the grip for replacing the trigger or motor armature.
What you need
Tools
-
T15 Torx Screwdriver$7.99
-
-
-
Remove the M3x16mm T10 screw from the back of the grip. Keep it separate from the rest of the grip screws
-
Remove the six M3.63x19 T15 screws from the grip.
Ask FixBot
-
-
-
Remove the top half of the grip.
-
Turn the saw over and locate the power connectors to the motor.
-
Use needle nose pliers to remove the spade connectors. Take care not to grab the wires on removal, only the end of the spade terminal.
-
-
-
To reassemble your device, follow these instructions in reverse order.
Team
Eastern Washington University, Team S2-G5, Munoz Winter 2019 Member of Eastern Washington University, Team S2-G5, Munoz Winter 2019
EWU-MUNOZ-W19S2G5
3 Members
84 Guides authored
