DJI Mini 3 Pro Disassembly
Arty and one other contributor
Last updated on Apr 17, 2023
Views: 23K
View statistics:
- Past 24 Hours:
- 18
- Past 7 Days:
- 92
- Past 30 Days:
- 445
- All Time:
- 23,151
Comments: 1
1 guide comment.
Go to guide commentsCompleted: 7 8
7 people have marked this guide "completed." Will you be next?
8 people have marked this guide "completed." Including you — great job!
Favorites: 2 3
2 people have favorited (and subscribed to) this guide. Will you be next?
3 people have favorited (and subscribed to) this guide — including you!
Community-Contributed Guide
An awesome member of our community made this guide. It was not created by iFixit staff.
Needs Transcription
This guide is in video form only. Help make it more accessible by transcribing each action of the procedure into a separate step and adding photos.
Introduction
Hi everyone, In this guide, I'll show you how to disassemble to replace the main parts of the DJI Mini 3 Pro drone.
Additional Information
After replacing the drone's GPS module, you will need to calibrate the drone in the DJI Fly mobile app.
To replace the ESC board and drone arms, you will need a soldering iron.
After replacing the motherboard, you will need to calibrate the gimbal camera.
Use this manual to calibrate the gimbal camera https://youtu.be/mu03HWXplM4
What you need
Tools
Video Instructions
To reassemble your device, follow these instructions.
Cancel: I did not complete this guide.
7 other people completed this guide.
1 Guide Comment
Wie kann ich die Heißklebestellen "materialschonend" lösen? Ich trau mich da nicht mit dem Heißluftgeläse ran.
Woifi - Reply Share