ColecoVision Motherboard Replacement
Krystalina and 2 other contributors
Last updated on Jan 5, 2019
Views: 2.5K
View statistics:
- Past 24 Hours:
- 3
- Past 7 Days:
- 22
- Past 30 Days:
- 103
- All Time:
- 2,545
Comments: 0
No one has left comments on this guide. Will you be first?
Go to guide commentsCompleted: 1 2
1 person has marked this guide "completed." Will you be next?
2 people have marked this guide "completed." Including you — great job!
Favorites: 0 1
No one has favorited (and subscribed to) this guide. Will you be the first?
1 person has favorited (and subscribed to) this guide — and that's you!
Introduction
Go to step 1 ↓The purpose of this guide is to give step-by-step instruction on how to replace the motherboard on a ColecoVision.
What you need
Tools
-
-
-
Start by laying the console face down.
-
Remove the eight 15mm Phillips #1 screws from the bottom of the device.
Ask FixBot
-
-
-
Flip the console back over.
-
Lift the front panel off. I would reccomended using a metal spudger along the rim of the top to safely remove it and set it aside.
-
-
-
Remove the two 15mm Phillips #1 screws holding the casing in place.
-
Carefully lift the casing from the motherboard.
-
-
-
-
Remove the center Phillips #1 screw near the cartridge slot.
-
Remove the second Phillips #1 screw near the RAM chips.
-
Carefully lift and remove the motherboard.
-
-
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Team
UW Tacoma, Team S1-G2, Rose Fall 2018 Member of UW Tacoma, Team S1-G2, Rose Fall 2018
UWT-ROSE-F18S1G2
4 Members
72 Guides authored
