Classen Over Seeder TS20HD 2012 Rake Belt Replacement

Disconnect the spark plug to prevent the engine from accidentally starting up during service:

Grab the plastic housing at the end of the spark plug wire.

Pull firmly to disconnect the wire from the spark plug.

To prevent the over seeder from rolling during service, place wheel chocks behind a rear wheel.

Push down on the main handle to tilt the over seeder back on its rear wheels.

Place some weights on the handle, or tie the handle down, to prevent the machine from falling forward.

Place a wheel chock in front of a rear tire to keep the machine in place.

Remove the four lock nuts securing the belt guard:

Two 1/2" lock nuts

Two 7/16" lock nuts

Remove the belt guard.

Use your fingers to pry the belt off the drive pulley.

Squeeze the belt and unhook it from the engine pulley.

Remove the rake belt.