Canon FS30 LCD Screen Replacement
Emanuel Keller and 2 other contributors
Last updated on Jun 8, 2017
Views: 884
View statistics:
- Past 24 Hours:
- 3
- Past 7 Days:
- 15
- Past 30 Days:
- 94
- All Time:
- 884
Comments: 0
No one has left comments on this guide. Will you be first?
Go to guide commentsCompleted: 1 2
1 person has marked this guide "completed." Will you be next?
2 people have marked this guide "completed." Including you — great job!
Favorites: 0 1
No one has favorited (and subscribed to) this guide. Will you be the first?
1 person has favorited (and subscribed to) this guide — and that's you!
Introduction
Go to step 1 ↓If your camcorder LCD screen is scratched, cracked or defective in any way, it will have to be replaced. This guide requires some tools and time.
What you need
Tools
-
-
-
Locate battery compartment cover. Turn the device over and locate the battery compartment cover.
-
Place a finger or thumb on the textured section of the battery compartment cover and push forward until you hear a click. Then lift the battery compartment cover.
Ask FixBot
-
-
-
Locate the grey latch and move it aside. The battery is spring loaded and will pop up.
-
Remove the battery.
-
-
-
Using the Phillips #000, remove the two screws on the LCD panel.
-
Using the Phillips #000, remove two more screws near the LCD panel swivel point.
-
-
-
-
Locate and remove two screws on the logic board.
-
Use the plastic opening tool to open the ZIF (zero insertion force) connector. The LCD ribbon should pop up.
-
-
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Team
USF Tampa, Team S1-G4, Nance Spring 2017 Member of USF Tampa, Team S1-G4, Nance Spring 2017
USFT-NANCE-S17S1G4
4 Members
60 Guides authored
