CR-10 V2 Print Head Teardown
Tiny Machines 3D and 2 other contributors
Last updated on Jun 26, 2024
Views: 9.6K
View statistics:
- Past 24 Hours:
- 5
- Past 7 Days:
- 27
- Past 30 Days:
- 88
- All Time:
- 9,576
Comments: 0
No one has left comments on this guide. Will you be first?
Go to guide commentsCompleted: 3 4
3 people have marked this guide "completed." Will you be next?
4 people have marked this guide "completed." Including you — great job!
Favorites: 0 1
No one has favorited (and subscribed to) this guide. Will you be the first?
1 person has favorited (and subscribed to) this guide — and that's you!
Community-Contributed Guide
An awesome member of our community made this guide. It was not created by iFixit staff.
What you need
Tools
-
-
-
Using M2 hex remove the 3 button head screws holding the print head to the X carriage plate.
-
Using M2 hex, remove the 4 screws holding the hot end fan in place (2 screws attach to the front half and the other to the rear)
-
Using M2 hex, remove 3 button head screws that secure front and rear sections together. Do not try to pull apart yet!
Ask FixBot
-
-
-
Using M2 hex, remove the 2 button head screws securing the part cooler fan. 1 attaches to the front and the other to 2 rear.
-
Pull the front half off to expose the rear section and hot end.
-
Now, treat it like an E3D V6 hot end. However, the nozzle is not V6 style.
-
-
-
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
3 other people completed this guide.
