Introduction
These are the first steps to taking apart the device.
What you need
-
-
Remove the five 30mm Phillips #0 screws on the bottom of the camera.
Ask FixBot
-
-
-
-
Use a plastic opening tool to disconnect the internal hinges that snaps the camera into place.
-
-
-
It will still be connected by a plastic film. This can also be disconnected by pulling up the white part where it connects to the light circuit board.
-
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Team
UMass Dartmouth, Team 8-4, Botvin Spring 2016 Member of UMass Dartmouth, Team 8-4, Botvin Spring 2016
UMASSD-BOTVIN-S16S8G4
3 Members
12 Guides authored
