Basis Peak Battery Replacement
Dominic Calcasola and 2 other contributors
Last updated on May 19, 2017
Views: 836
View statistics:
- Past 24 Hours:
- 4
- Past 7 Days:
- 19
- Past 30 Days:
- 89
- All Time:
- 836
Comments: 0
No one has left comments on this guide. Will you be first?
Go to guide commentsCompleted: 0 1
No one has marked this guide "completed." Will you be the first?
1 person has marked this guide "completed." It's you — great job!
Favorites: 0 1
No one has favorited (and subscribed to) this guide. Will you be the first?
1 person has favorited (and subscribed to) this guide — and that's you!
Introduction
Go to step 1 ↓This guide gives you the information you need to replace the battery on the Basis Peak product. Each step is shown with pictures to make sure you won't get lost through your work. Its quite simple to get through especially with the helpful guidance provided. There's no tricks and the product can only be dissemble through this one way.
What you need
Tools
-
-
-
Flip the watch over and orient it such that the buckle is away from you and the back panel is revealed.
Ask FixBot
-
-
-
Remove the four base screws using a size 2 TORX screwdriver to separate the back plate from the frame.
-
-
-
Disconnect the ribbon cable on the left side of the motherboard by using a spudger.
-
-
-
Use a spudger and apply pressure to the white plastic wall to the right of the motherboard. Use this to lever the electronics out of the frame.
-
-
-
-
-
Remove the right side ribbon cable by pulling it off with your fingers.
-
-
-
Use the spudger tool to poke out the exposed motherboard section as seen in the photo.
-
-
-
-
Put a nylon spudger underneath the battery's press-fit connector and lift up to free the ribbon cable and motherboard.
-
-
-
To reassemble your device, follow these instructions in reverse order.
Team
UMass Dartmouth, Team S4-G4, Julie Spring 2017 Member of UMass Dartmouth, Team S4-G4, Julie Spring 2017
UMASSD-JULIE-S17S4G4
4 Members
60 Guides authored
