Introduction
Use this guide to replace the right bumper in your Backbone One.
What you need
-
-
Use a Phillips screwdriver to remove the four 5.9 mm-long screws.
Ask FixBot
-
-
-
Lift up the upper cover of the controller.
-
Swing the upper cover over and place it on the controller case.
-
-
Tool used on this step:Tweezers$4.99
-
Use a pair of tweezers to remove the yellow protective tape which is placed over the interconnect cable and the connector.
-
-
-
Use the tip of an opening pick to open the gray flap of the interconnect cable ZIF connector by pushing it upwards.
-
-
-
-
Disconnect the cable by pulling it straight out the ZIF connector.
-
-
-
Use a pair of tweezers to disconnect the phone connector cables out from their sockets.
-
-
-
Separate the the upper case of the left controller handle.
-
-
-
Use a Phillips screwdriver to remove the three 5.9 mm-long screws.
-
To reassemble your device, follow these instructions in reverse order.
Repair didn’t go as planned? Ask our Answers community for help.
