Axess SPBT1031 Buttons Replacement
Elvira Lou Evangelista and 6 other contributors
Last updated on Mar 24, 2021
Views: 2K
View statistics:
- Past 24 Hours:
- 3
- Past 7 Days:
- 18
- Past 30 Days:
- 85
- All Time:
- 2,049
Comments: 0
No one has left comments on this guide. Will you be first?
Go to guide commentsCompleted: 1 2
1 person has marked this guide "completed." Will you be next?
2 people have marked this guide "completed." Including you — great job!
Favorites: 0 1
No one has favorited (and subscribed to) this guide. Will you be the first?
1 person has favorited (and subscribed to) this guide — and that's you!
Introduction
Go to step 1 ↓This guide will be helpful for repairing the buttons in the speaker if the troubleshooting page recommends that you replace the battery. This is a necessary step when you have determined no other way to repair your current battery. Be wary of accidentally damaging other parts of the device when replacing the buttons.
What you need
Tools
-
-
-
Use a metal spudger to remove the mesh speaker covers (the side with the buttons) by wedging the narrow end into the center of the outer edge of the mesh, touching the red plate.
Ask FixBot
-
-
-
Remove the four 5 mm screws from the red panel under the mesh using a Phillips #1 screwdriver.
-
-
Tool used on this step:Tweezers$4.99
-
If the screws are difficult to remove, use a pair of tweezers to twist and pick them out.
-
-
-
Separate the red interface plate from the black face plate by pulling them apart.
-
-
-
-
-
-
Push the set of buttons inward from the outside of the red plate and peel off from the inside.
-
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Team
UMass Dartmouth, Team 8-6, Botvin Spring 2016 Member of UMass Dartmouth, Team 8-6, Botvin Spring 2016
UMASSD-BOTVIN-S16S8G6
3 Members
96 Guides authored
