Introduction
Before replacing any components on the Arnova 7K G3 tablet, disassembly is required. That process starts with removing the rear cover to gain access to a majority of the components including the battery, speaker, and logic board.
What you need
-
-
-
Remove four 5 mm Phillips #00 screws from each corner of the tablet.
Ask FixBot
-
-
-
-
Place the iFixit opening tool in the notches between the cases and pull the covers apart.
-
-
-
Repeat step two until 3/4 of the rear cover is unlatched.
-
Proceed to remove the rear cover by gently pulling it apart by hand.
-
-
To reassemble your device, follow these instructions in reverse order.
Team
Michigan Tech, Team 1-2, Lauer Spring 2015 Member of Michigan Tech, Team 1-2, Lauer Spring 2015
MTU-LAUER-S15S1G2
2 Members
60 Guides authored
