Free Shipping on Domestic Orders $75+

Introduction

Is the camera not showing anything, taking blurry pictures, or lagging when taking pictures? This guide will show you how to replace the camera on an Alcatel Go Flip Phone 4.

Before replacing the camera, check out our troubleshooting page to make sure the lag and black screen is caused by the camera and not another factor.

Step 1 requires an iOpener to detach the display frame. For additional information on how to use it refer to this guide here.

Before beginning this repair, make sure to power off your phone and have it unplugged from the charger.

What you need

Step 1 Camera

Alcatel Go Flip 4 Camera Replacement, Camera: step 1, image 1 of 1

Heat the screen cover with an iOpener to soften the adhesive holding it to the display frame.

Edit

Step 2

Insert a Jimmy under the screen cover to pry it open.

Edit

Step 3

Alcatel Go Flip 4 Camera Replacement: step 3, image 3 of 3

Use plastic opening picks to separate the adhesive.
Add more heat as needed.

Edit

Step 4

Remove the plastic screen cover and set it aside.

Edit

Step 5

Remove the four 3.5 mm screws holding the rear cover in place using a JIS #00 screwdriver.

Edit

Step 6

Starting at the hinge side, insert the Jimmy between the rear cover and the display's frame.
Continue down the side of the phone, releasing clips as you go.

Edit