ASUS ZenWatch Charging Cradle Circuit board Replacement - iFixit Repair Guide

Free Shipping on Domestic Orders $75+

Introduction

Replacing the circuit in the charging cradle

What you need

1. Step 1 Charging Cradle Circuit board
  Using a metal spudger gently pry the plastic outer case apart
  
  Pry open a little bit on each side before trying to open fully
  Edit
  
  Ask FixBot
  
  Add Comment
  
  1024
3. Step 2
  Use the PH0 sized Phillips screwdriver to remove the three screws (2mm) holding the board to the cradle.
  
  Gently pry up with your hands to pull the board off.
  
  Don't grab directly on the USB port as you may loosen or bust the connections.
  Edit
  
  Ask FixBot
  
  Add Comment
  
  1024

Conclusion

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

with 2 other contributors

Wayne McClure

Member since: 02/10/16

961 Reputation

5 Guides authored

+12 more badges

Team

USF Tampa, Team 1-3, Sullivan Spring 2016 Member of USF Tampa, Team 1-3, Sullivan Spring 2016

USFT-SULLIVAN-S16S1G3

4 Members

24 Guides authored

1 Guide Comment

If you had listed what components were on the board or at least taken a picture of the other side of the board, I might have given you some points.

Nate Fansler - Aug 24, 2016 Reply Share

View Statistics:

Past 24 Hours: 2

Past 7 Days: 10

Past 30 Days: 35

All Time: 3,244