Camera Motor Replacement
3 pages · 2.67 MB · PDF
Roku Indoor Camera 360 SE (CP1000X) - Camera (Tilt) Motor Replacement
Introduction
This guide covers removing the camera rotating (tilt) stepper motor (24BYJ48 461D) from the camera head assembly.
Prerequisites
Complete the Back Panel Replacement guide first.
What you need
Small Phillips screwdriver
Tweezers
Step 1 - Disconnect the tilt motor plug
Locate the tilt motor's 5-pin connector on the main board (blue box) under the motor connected to the rotating base (red box). Using tweezers or a plastic spudger, pull the plug straight out. Do not pull by the wires.
01-V2.3 喇叭座台
Motor Connectors on Main Board
Step 2 - Remove the tilt motor screws
The tilt motor is held in place with 2 screws inside the camera head bracket. Remove both screws.
