It has a screen changed and the rear, front camera doesn't work. I bought today as it is.

Can be any chances by the screen causing restarts ?

I read some articles that can be the Charger cable flex thing or proximity sensor flex , but i'm not sure. :(

I disconnected the charger cable flex and keep restarting.

panic(cpu 0 caller 0xfffffff02b8469ac): SMC PANIC - ASSERTION FAILED: target/d16/target.cpp:263: 0, SMC BSC failure, spreadsheet ver(*10) 190

S.sensor array 0 - 6 is 0x0, 0x400, 0x0, 0x0, 0x0, 0x0, 0x0

F.sensor array 0 is 0x0

- Misc(2) OUTBOX1 not ready

ASSERTION FAILED: target/d16/target.cpp:263: 0, SMC BSC failure, spreadsheet ver(*10) 190

S.sensor array 0 - 6 is 0x0, 0x400, 0x0, 0x0, 0x0, 0x0, 0x0

F.sensor array 0 is 0x0

#

⟐ Commented July 10, 2024 at 16:24 MST

Just for reference, here is the battery life draining today with minimal use of the phone (especially between 6-9AM).

⟐ Answered March 30, 2025 at 6:23 MST

I hear the repair assistant is still new and very flaky, but I was wondering if I can still finish the repair. Also, is there a point in contacting Apple support about this?

⟐ Commented November 24, 2025 at 11:42 MST

I did a Housing swap with a wireless charging pad installed and other small parts preinstalled. Now the customer's Apple pay is not working I think it might have to do with the wireless charging pad possibly part is serialized. Has anyone else come across this issue yet? Do you know what part is connected to apple pay?

⟐ Answered April 08, 2023 at 20:20 MST

⟐ Commented February 27, 2026 at 17:33 MST

⟐ Answer unaccepted June 07, 2022 at 13:43 MST

Thank you

⟐ Answered April 21, 2022 at 15:39 MST

[Help] Did screen pop off screen frame?

Hello, I am replacing battery on iP 13 mini and looks like lcd screen came apart from screen frame. I have never seen or heard about it before, does anyone know how to proceed here? I am worries about face id sensors since the top part wont come loose when I try to separate it.

Thanks

⟐ Answer edited February 16, 2025 at 12:50 MST

What exactly might have happened at board level?

I guess something has moved on the board.

If I use a heat gun on the board, is it possible to solve the problem, or is the board-level repair going to be more complicated?

⟐ Answered May 25, 2023 at 12:06 MST

⟐ Answered February 12, 2024 at 11:30 MST

I suspect that my wife's iPhone 13 Mini's wifi antenna is bad. It will occasionally show the WAP but then it disappears. It is NOT greyed out as in other posts.

I've found the part to order here on iFixit but I cannot find detailed instructions on how to replace it. Can someone point me to a how-to article or even video? Thanks.

⟐ Answer accepted May 23, 2023 at 5:20 MST

⟐ Answered November 04, 2022 at 11:56 MST

my iPhone 13 Mini crashes and restarts every 3 minutes. Error log shows SMC BSC failure of type 0x1000 , which should be the proximity flex cable. However, after disconnecting it, the error continued to exist. Is this possible? Should I still change the proximity flex cable altough disconnecting it didn't result in a fix?

⟐ Commented April 27, 2024 at 8:18 MST

Currently, the phone is running the latest version of iOS (18.3.1), and I'm curious as to what parts are salvageable, or if the phone is just now a complete paper weight.

Any advice or knowledge would be greatly appreciated. :)

⟐ Commented October 25, 2023 at 2:23 MST

• WiFi disconnects constantly (especially when gaming)
• Bluetooth range/connection is terrible
• Screen flickers on home screen

Already tried the usual WiFi resets, forgetting networks, etc. – no change.

Questions:

1. On the 13 mini, are WiFi and Bluetooth handled by the same chip or antenna flex cable?
2. Could a botched screen replacement (tons of leftover glue, possibly damaged flexes) cause both WiFi and BT issues?
3. Any specific things to check inside?

Thanks so much!

⟐ Answered December 10, 2025 at 8:11 MST

Is this still a problem for the 13 mini? or has the page just not been updated yet?

I just want to make sure before I buy a replacement screen so I don't waste my money :)
Thanks!

⟐ Answered September 27, 2024 at 6:24 MST

It happens both off and on the charger. I'll be using it normally (or it will be sitting unused), and it will suddenly change to a black screen with a spinning wheel, shut off, and then reboot to my lock screen. Sometimes it will only do it once, but sometimes it will do it over and over again, for up to an hour. The phone is completely unusable while it's stuck in this cycle. It always gets extremely hot during. Charging or removing it from the charger sometimes makes a difference, but often doesn't. It sometimes makes a clicking/snapping sound when it's shutting off, similar to the haptic but louder.

I bought the phone brand new, and this problem started the instant the 1 year warranty ended. If it's a battery issue, I would like to take a stab at it myself, but someone else told me that the phone getting hot is indicative of a CPU issue. If it's CPU, I won't waste time with the battery. If anyone has any idea what the problem is, please let me know! Thank you!

ETA: panics and strings. They don't look very legible in the preview, so please let me know if I need to edit again.

⟐ Commented September 10, 2024 at 19:27 MST

⟐ Answered November 08, 2025 at 13:19 MST