iFixit - Answers With Device "Yamaha Motorcycle"

Yamaha Motorcycle: horn, indicator and all working fine but the starter is not working.

Thu, 02 Apr 2026 02:12:02 -0700

starter not working properly

⟐ Commented April 02, 2026 at 2:12 MST

Yamaha Motorcycle: Wiring Diagram for DT400

Mon, 30 Mar 2026 14:01:32 -0700

Anyone have a service manual or electrical diagram for a 1975/76 yamaha DT400 ? I cant seem to figure out the scematic.

⟐ Commented March 30, 2026 at 14:01 MST

Yamaha FZ6: My CDI is burned

Sat, 07 Mar 2026 10:50:19 -0700

Maine apne bhai ko start Kiya race and his CDI is burning

he is a burning

⟐ Commented March 07, 2026 at 10:50 MST

Yamaha FZR1000: Why will the bike not start?

Wed, 04 Mar 2026 04:12:12 -0700

this is a 1987 fzr 1000.It won’t start.the starter works and engine spins but it won’t fire up.there is plenty of gas.

⟐ Commented March 04, 2026 at 4:12 MST

Yamaha FZ6: Bike chain problem While riding it sound bad

Thu, 12 Feb 2026 07:52:57 -0700

Bike chain problem

While riding it sound bad

⟐ Edited February 12, 2026 at 7:52 MST

Yamaha FZ6: My rear disk brake not working properly..how to repair it?

Thu, 12 Feb 2026 01:57:38 -0700

Bike havung rear disk break..i have added brake fluid..and even new break pads..but break is still lose..how to make it tight..

⟐ Answer edited February 12, 2026 at 1:57 MST

Yamaha Motorcycle: Kenapa stater tangan tidak nyala Why doesn't the hand starter light up

Fri, 09 Jan 2026 01:31:16 -0700

Batrei bagus lampu jadi tapi stater tangan tidak jadi

The battery is good, but the lights work, but the hand starter doesn't.

⟐ Commented January 09, 2026 at 1:31 MST

2004-2009 Yamaha Vino 125: no electric to horn, lights, and starter

Wed, 26 Nov 2025 00:10:57 -0700

tried to start scooter after a long winter, but nothing. tried charging the battery, and still nothing. replaced the battery and still nothing. no lights, no horn and no attempt to start even with a new battery,

⟐ Answered November 26, 2025 at 0:10 MST

Yamaha Motorcycle: Headlight and gauge illumination failed simultaneously

Tue, 21 Oct 2025 18:14:53 -0700

I replaced the battery on my 1995 Yamaha XV1100 (Virago) as the old battery was just too tired. It started and ran great. Passed the mandatory NYS inspection. Everything was working fine. Parked the bike for a couple of hours when I got home. When I went to put it in the garage, I started it (no problem there) and I noticed that neither of the gauge lights was illuminated. I then noticed that the headlight was also not lit. All other lights and electrical accessories (except the high beam indicator) work as normal (taillight, park lights, brake light, turn signal and indicator lamps, oil pressure light, neutral indicator light, horn, heated grips). The headlight bulb does not appear to be burnt and there is continuity between the terminals on the bulb. The four fuses under the indicator light panel are good. So far I've looked in the headlight bowl and under the seat and the wiring looks solid (no visible corrosion or worn insulation). Jiggling the wires with the ignition switch on does not produce any effect. The bike starts and runs fine and all other lights still work fine. I have the Clymer manual for this bike but it says practically nothing about the lighting system. Any suggestions would be appreciated as I am not good at electrical problems.

I appreciate your patience and understanding.

⟐ Commented October 21, 2025 at 18:14 MST

Yamaha Motorcycle: My bike not self starting, but starter motor and kick starting works.

Thu, 16 Oct 2025 02:53:11 -0700

I have a yamaha gladiator 125 bike. Its not self starting but starter motor works. When i take my bike a long ride and it heat up self start is working when the engine is in higher heat. Previously i had to change the coil pack due to not starting both kick start and self start. Bike works fine after change the coil pack but self start not worked. Need help.

⟐ Answered October 16, 2025 at 2:53 MST

Yamaha Motorcycle: Preciso do manual técnico da Yamaha Morphous/Maxam CP250 2008

Sat, 12 Jul 2025 03:36:01 -0700

Preciso do manual técnico da Yamaha Morphous/Maxam CP250 2008

⟐ Answered July 12, 2025 at 3:36 MST

Yamaha Motorcycle: Mengapa motor saya selalu ngadat ngadat

Fri, 30 May 2025 00:35:37 -0700

Setelah mengganti blok dan karburator motor f1zr saya selalu ngadat ngadat

Why is my motorbike always acting up?

After replacing the block and carburetor, my F1ZR motorbike always acts up

⟐ Edited May 30, 2025 at 0:35 MST

Yamaha Motorcycle: solenloid decompression problem. Solved!

Thu, 29 May 2025 04:16:09 -0700

Road Star XV 1700 2006, solenloid pushes the two rods in, but valve does not stay open to decompress. Anyone an idea ? Cheers. Two days later : After opening up the crank-carterI, I found one of the two rod- levers was slightly bent, so it didn't push in the decompression-rod enough to engage the extra crank-opening-moment of the exhaust-valve.

⟐ Answer accepted May 29, 2025 at 4:16 MST

Yamaha Motorcycle: Starting problem possibly electrical?

Mon, 26 May 2025 01:37:28 -0700

My 2000 Road Star 1602 has had a problem for many years now.

The thing won't start until the speedo sweep has finished and the yellow light does a faint blink.

I have taken the cover off of the decompression assembly, and it doesn't activate until the faint blink.

It cranks pretty good considering the decompression spoon isn't activated for a time!

I've read the manual and have checked all of the electronic connections.

I suspected the ignition unit since the schematic shows a direct connection between it and the decompression unit. Replaced it with 2 other units to no avail.

Any clue where to look next?

The battery, starter, starter solenoid and rectifier have been changed.

⟐ Answered May 26, 2025 at 1:37 MST

Yamaha Motorcycle: Jalur kabel pengisian aki mx 135 old

Sun, 25 May 2025 07:35:26 -0700

Jalur pengisian motor mx 135 old tidak ada api

Translation

Indonesian - English

The charging line for the old MX 135 motorbike has no spark

⟐ Edited May 25, 2025 at 7:35 MST

Yamaha Motorcycle: Oil light came on , but it's full

Wed, 14 May 2025 16:15:57 -0700

My oil light came on , on my 96 Yamaha virago 750. I changed the oil and filter, but it still is on. My pump is still working and I don't have any leaks. Iit doesn't have an oil sensor, it has a switch, which doesn't help me, cause I know nothing about that. Don't how to check that, not sure if you even can. Not sure what else to do.

⟐ Commented May 14, 2025 at 16:15 MST

2004-2009 Yamaha Vino 125: Fuel leaking from an open hose coming from bottom of carburetor I

Wed, 26 Feb 2025 07:52:03 -0700

Trying to figure out why fuel leaks steadily out of a very small hose coming from be very bottom of the carburetor. Hose does not appear to attach anywhere seems like an open hose. Leaks only when running. Also a thicker hose coming from mid carb leaks some as well while running. That hose Appears to be a vent hose of some sort and is sliced add a 45 at the end. Final note I have got the scooter to run smoothly but just facing these leaks any information would be greatly appreciated , the gas tank is nowhere near full checked already.

⟐ Commented February 26, 2025 at 7:52 MST

Yamaha Motorcycle: wiring schematic for FZ-07

Mon, 03 Feb 2025 10:02:48 -0700

need wiring diagram for 2016 FZ-07, crank but no start, 0nly 1.3 volt going to fuel pump during crank

⟐ Commented February 03, 2025 at 10:02 MST

Yamaha Motorcycle: Gmn cara perbaiki fuelpump Mio j yang mati

Tue, 24 Dec 2024 02:10:02 -0700

Gimana cara perbaiki fuelpump Mio j yang mati

⟐ Commented December 24, 2024 at 2:10 MST

Yamaha Motorcycle: VStar issue please help

Wed, 11 Dec 2024 09:18:40 -0700

I have a 2000 Yamaha VStar 650. I can’t get it to turn over. We have tested everything electrically and found a few things so we replaced the ECU, spark coils, spark plugs, combo relay, inspected stator, tested stator according to manual. Compression was great. Output from the stator was in spec. The trigger wire from coil to ECU has continuity and no grounds.

We are getting weak spark in front cylinder and no spark in the rear cylinder.

Pulse coil has been checked and according to the manual is good.

Probed wire harness as per manual and everything tested good. Killswitch, key switch and kick stand switch we’re all tested and found to be good but we even bypassed them from the circuit.

We have no more hair on our heads now and need help! Lol please!

Thank you Brett Hodsden

⟐ Commented December 11, 2024 at 9:18 MST