<![CDATA[iFixit - Answers With Device "XBR-65X750D"]]> https://www.ifixit.com/Answers/Device/XBR-65X750D?rss=yes en-US Fri, 08 May 2026 07:35:06 -0700 <![CDATA[XBR-65X750D: Can you fix a cracked screen on a Sony Bravia TV?]]> I cracked the screen on my 65’ Sony Bravia TV, and I would like to know if it is repairable and if so, get an estimate.

⟐ Commented January 12, 2025 at 22:38 MST

]]> https://www.ifixit.com/Answers/View/793882/Can+you+fix+a+cracked+screen+on+a+Sony+Bravia+TV https://www.ifixit.com/Answers/View/793882 Sun, 12 Jan 2025 22:38:49 -0700 <![CDATA[XBR-65X750D: My Sony TV is stuck on the loading screen]]> My Sony Tv is stuck on the loading screen and it shows four color circles. Can you help, please?

Update (12/18/2022)

Block Image
Block Image

⟐ Edited by author December 19, 2022 at 1:13 MST

]]> https://www.ifixit.com/Answers/View/760059/My+Sony+TV+is+stuck+on+the+loading+screen https://www.ifixit.com/Answers/View/760059 Mon, 19 Dec 2022 01:13:34 -0700 <![CDATA[XBR-65X750D: Five blinking red lights]]> Hi I have a Sony XBR-65X750D. It has 5 blinking red lights when I turn on the tv. Almost looks like the screen is about to power on then bam. I have tried to replace the T-Con board but still have the same issue. I have tried to power reset as well. I did though however notice when I disconnected the lvds ribbon from the T-Con to the right board (main? One with all the inputs) it will turn on with no code but won't display a picture (assuming T-Con controls that) I have inspected the ribbon cable and have not seen and burn or marks that would make me think it's the ribbon. What should I be doing next?! Help!

]]> https://www.ifixit.com/Answers/View/829427/Five+blinking+red+lights https://www.ifixit.com/Answers/View/829427 Fri, 22 Dec 2023 18:48:06 -0700 <![CDATA[XBR-65X750D: Sony 5 blink error, only boots when T-Con to left panel disconnected.]]> My Sony XBR-65X750D has a 5 blink error code. The backlight turns on but shuts off after about 10 seconds when the error code starts. When I disconnect the t-con cable to the right side of the panel it still gives the error code. When I disconnect the t-con cable to the left side of the panel the TV boots up. After booting up, for about a week there was only audio, but now the picture has started working on the connected (right) side.

I bought replacement t-con and main boards, which I tried, but they didn’t make any difference. I opened the diagnostic screen, which shows an error, but since I can’t see the left side of the screen I don’t know what it is :(

Any suggestions for where to go next? At this point I assume it’s either the power supply board or the panel driver board. As far as I can see there are no visible signs of failure on any of the boards. I’m learning as I go and haven’t found any service documentation on this particular TV so I’m not really sure what to test next.

Block Image
Block Image
Block Image
Block Image
Block Image
Block Image

⟐ Edited by author April 14, 2021 at 13:38 MST

]]> https://www.ifixit.com/Answers/View/688396/Sony+5+blink+error,+only+boots+when+T-Con+to+left+panel+disconnected. https://www.ifixit.com/Answers/View/688396 Wed, 14 Apr 2021 13:38:21 -0700