⟐ Answer edited April 20, 2025 at 12:34 MST

⟐ Commented April 01, 2026 at 16:29 MST

I checked the breaker, it was not tripped. I tried turning it off for several minutes. When the power is turned back on, the "Door Lock" indicator light next to the "Heated Dry" button, blinks for about 60 seconds or so, then stops and the "Normal" light starts flashing again. The reset sequences mentioned in the owners manual, as well as those in other posts have had no effect, the only lights that come on are the 2 mentioned.

I tested both door latch microswitches for continuity, they are good. The thermal electronic fuse is good as well although I havent tested for voltage because I'm not sure where to touch the ground probe without causing more damage. I've disconnected each wire to check for any burnt connectors and also checked the control board on both sides for any heat damage or poor solder connections. Everything appears fine. Any help would be greatly appreciated! Thank you!

⟐ Commented August 11, 2025 at 11:00 MST

⟐ Commented July 10, 2023 at 12:11 MST

⟐ Answered January 18, 2022 at 16:37 MST

⟐ Answered November 28, 2025 at 9:56 MST

⟐ Answered June 16, 2024 at 15:11 MST

⟐ Answer edited May 17, 2024 at 9:14 MST

⟐ Answer edited February 08, 2021 at 8:07 MST

⟐ Commented March 01, 2024 at 10:57 MST

So I disconnected power and the ribbon cable to the board. Reassembled and was able to run a normal cycle as it should work. All seems ok. Thanks for the help

⟐ Edited by author December 01, 2022 at 17:19 MST

Flashing lights on the Board panel...Buttons: “Normal” & “Rinse Only”

Approx. 13 years old.

I can not understand why lights just came on. Only used approximately 4 times.

I disconnected power from the electric circuit breaker in hopes it would re-set.

What can I do to re-set from the Board Panel?

Desperate Lady…Please Help!!

⟐ Edited by author June 20, 2020 at 15:29 MST

⟐ Answered August 04, 2024 at 17:45 MST

⟐ Answer edited August 06, 2022 at 20:30 MST

⟐ Commented April 02, 2021 at 20:53 MST

⟐ Answer edited December 24, 2024 at 19:53 MST

⟐ Answered June 28, 2024 at 10:33 MST

⟐ Answer edited May 17, 2024 at 7:57 MST

What is the problem please

⟐ Answer unaccepted February 19, 2023 at 11:56 MST

The entire display is unlit except the above 3 buttons furthest to the left: pots and pans, normal, and light. Those 3 have the faintest green dot in the middle. While the buttons are being pressed the dot will disappear and reappear once i stop pressing.

I am actually able to press the drain and start button and both function initially, start will begin a cycle and all buttons will light up normally, but it will return to the same state before finishing the complete cycle. Sometimes the normal button will flash for a bit before doing so.

Im at a loss what the issue could be.

⟐ Commented February 08, 2023 at 21:09 MST