When I plug a 3.5mm jack cable in sample mode nothing happens.

The displays stays in MIC instead of switching to LR. I assume this is a hardware problem but I'm not sure about it. Is there any way to fix the stereo jack 3.5mm input ?

Thank's

Alain

The product is out of warranty, is there a simple fix?

I have a question, after coming all the way to Brasil with my op-z looking for someone to fix it, which i found just in Berlin for now.

My Op-z is 40% fixed by now (it was problems of dirty inside, humidity, etc) and now, Tom, which fix for SchenidersLaden with his team, told me that i should find some Front Buttoms Pcb for it, to continue the fixing - ‚cause some of them are not working properly, and this bothers me while composing.

Do you guys have some of them - used or new - to sell or give it to me or know where i could find it?

This would help a lot not just my artistic carreer, but my lufe as a whole.

I keep searching from here,

Wishing again all the best for your

Kindly

Pedro Máia

Obs.: By the way, the op-z module and the cables that i got from you are working pretty well! Just the cable of charging the op-z that lost all it‘s skin, so it‘s like crude now, with the silver cables inside appearing - could it be harmful for me?

Thanks,

Jared

My first issue is the audio is only outputting a signal from the right side. I've checked the sync settings and in the mixer everything is being sent down the middle. I get a tiny output from the left side but it's very quiet and distorted. I have tried multiple cables and the OP-1's output settings too.

My second issue is that my OP-1 will often just turn itself off, go to restart, then crash. Sometimes it will turn back on and other times it won't until I reinstall the firmware. It keeps happening and won't consistently stay on for more than 30 minutes. ⏎

I really want to use my OP-1 for my live show but I can't in this state. Any advice is deeply appreciated! I've replaced the connector board recently (twice!) and the problems still persists. Thanks ⏎

I currently have an op-1 dsp which doesn't turn on and I need to access the recovery menu to upload firmware, but I am missing the keyboard for it and it's currently out of stock.

Would someone be able to tell me which 2 pins on the keyboard flex cable or the ui board ffc connector are used for the com key?

My OP-1 wasn't getting recognized over USB, so after some lengthy research I bought a new connector board replacement but it didn't change anything. My OP-1 will charge and turn on but It won't show up as a drive in any computer that I've tried. PLEASE HELP.

My little machine took a bit of a tumble (oops my bad) and I broke the orange adjustment knob. I took it into my boy at my local music shop, and he gave it a good repair attempt, but it was no good. He said he thought he may be able to fix it if I could get a replacement knob component, which is easier said then done.

Like I've mentioned, I've already reached out to TE directly, but I was wondering if anyone had any hot gossip about K.O. II pieces-- any quirkly little freaky bootleggers who could give me a handy. Or whatever. Hopes are low, but Idk I'm feeling lucky, baby.