iFixit - Answers With Device "Protocol Dronium Two"

Protocol Dronium Two: Protocol drone motor replacement

Thu, 26 Sep 2019 19:33:08 -0700

One of my drone propellers are not rotating.I want to replace it.How to remove it?

Protocol Dronium Two: How do you replace the large gear?

Sat, 13 Oct 2018 15:05:17 -0700

My Protocol Dronium Two has some stripped teeth on one of the large gears that mesh with the small motor gear. I have got a replacement gear (and shaft). Does the gear pull off the shaft? and how hard?? Seems very tight. Does the shaft need to be replaced also, it does not seem to be damaged. Not sure how hard to pull on the gear?

⟐ Answer accepted October 13, 2018 at 15:05 MST

Protocol Dronium Two: Water damage on drone circuit board

Sun, 20 Aug 2017 19:17:54 -0700

I landed the drone in some water on accident and was wondering if i could get a spare circuit board somewhare

⟐ Commented August 20, 2017 at 19:17 MST

Protocol Dronium Two: Prop Spins Intermittently while other props spin perfectly

Tue, 01 Aug 2017 05:00:40 -0700

Drone Issue:Props spins and after remotely stopping all props, the rear right prop will sometimes not spin unless you give it a push. I carefully removed the cover revealing gears and saw nothing unusual. I tested the shaft by starting props and the shaft in question does not spin on its own. If you turn it the shaft will spin again and MAY behave fine for two or three test but eventually it will require that you spin shaft manually to get the shaft spinning. Is this a loose wire problem? Thanks for any suggestions.

⟐ Answer accepted August 01, 2017 at 5:00 MST