Already tried putting a pipe on it, didn't work. And tried clogging it up with tires and golf balls, didn't work.

Now trying to pump fluids and heavy mud into it to stop the flow, but no idea if that will work.

Any suggestions are welcome as this is becoming a major problem.

Please call: (281) 366-5511 if you have a good suggestion.

I don't have a picture, but I do have a webcam.

If we can figure out how to stop this thing we'll all be famous, so any ideas?

Pumping mud into it didn't work, now trying to put another tube on it?

now trying to put a THIRD dome over it...

Okay new complication, a ^^*# robot that was supposed to be sawing off a pipe is stuck in there now.

So now a key pipe has been cut, hopefully this makes things easier

So now there are some giant underwater plumes appearing, some as large as Rhode Island.

Any ideas on how to clear those up?

⟐ Answered February 10, 2026 at 6:44 MST

⟐ Answer accepted June 17, 2025 at 6:13 MST

⟐ Answer edited July 13, 2024 at 11:58 MST

I am using amazfit gts 2 mini

⟐ Commented April 12, 2024 at 22:37 MST

Obviously it’s a INA219B, but which one? There seems to be a whole lot of them

⟐ Commented February 20, 2024 at 0:20 MST

(Found some little dots of mold on my Laptops Fan when trying to clean it and removed them with an anti-Static desinfectent. No the less I’m sure I didn’t get all of it)

⟐ Answer accepted January 04, 2025 at 15:02 MST

Ultimately, trying to avoid unnecessary finger burns when holding down circuit boards when chipping off or soldering etc. Seeking something that can withstand chip-off heat but keep devices held in place.

Imagining something phone/tablet sized that has heat-resistant clamps that i can move around on a soldering pad under a microscope.

⟐ Answer edited August 12, 2024 at 9:49 MST

I don't suppose the pyrography tips would be suitable for soldering small electronics. I also don't think I will get anything back from the seller. So, before I go and resell it again, my question is whether it would be possible to buy soldering iron which I can connect to this pyrography station I got.

This is the connector the station uses

Or maybe it would be suitable for soldering as well? I'm really not sure, would appreciate some tips as to what exactly should I do with this thing...