<![CDATA[iFixit - Answers With Device "Other Brand Rotary Hammer"]]> https://www.ifixit.com/Answers/Device/Other_Brand_Rotary_Hammer?rss=yes en-US Wed, 15 Jul 2026 09:52:29 -0700 <![CDATA[Ryobi Hammer Drill SDS65 2016: Correct sequence to assemble the transmission.]]> Hello community, recently I brought this Ryobi SDS65. Went I finally goin make the first use, I notice that rotary hamner mode wasn't engaging, the drill and the chissel mode works well. I proceed to openen and check the issue because I throw to the trash the box some weeks ago. Went I open the transmission chamber everything pop out 😑. I already found the issue (selector rod was jammed with him self), but due to the pop out of the assemblies, not know the correct position of the pieces. I do some reverse engineering and have some advances, but I stuck here, and went I try to putted back to the chamber, not fit well, soo I don't know if I assembled the pieces correctly and don't know the trick to assemble back to the chamber without everything dismount again and fit well.

⟐ Commented June 30, 2026 at 15:13 MST

]]> https://www.ifixit.com/Answers/View/961874/Correct+sequence+to+assemble+the+transmission. https://www.ifixit.com/Answers/View/961874 Tue, 30 Jun 2026 15:13:51 -0700