Switch 2 with both charging ports damaged. Replaced both ports and only 2 data lines were damaged on the main bottom port. Installed new lines and they show good on tester. There were 6 total ground lines damaged. 3 on top and 3 on the bottom. Replaced both ports and both ports are getting .512 amps. System is not jumping to the next stage to charge or turn on system. Not sure where to look on these. I don't see anything like a M92/P13/BQ or caps that test/look bad. Has anyone else had anything similar that was obvious? Much thanks for any guidance.

⟐ Commented July 22, 2026 at 22:15 MST