iFixit - Answers With Device "Neato Botvac 80"

Neato Botvac 80: Getting "Press OKAY to continue (3000)" error - help?

Tue, 23 Apr 2024 11:47:12 -0700

Error 3000 - Neato does not start moving

My Neato Botvac 80 has been working well. Today I changed its battery. It was working well until now. It gets ready to start but then stops and give me the message “press OK to continue (3000)”. I press OK and it tries to get ready but again stops and sends the same message.

What did I do? I cleaned its laser area with a cotton tip and pressured air too. Nothing. The disk moves though.

Any suggestions on what could happen but mainly how to fix it?

Thanks!

⟐ Answer accepted April 23, 2024 at 11:47 MST

Neato Botvac 80: Neato Botvac D80 issue.

Tue, 26 Jan 2021 13:04:23 -0700

I own 2 of these units (identical). By swapping a couple parts I have determined that the battery, and charger base are not the problem. Bad unit has no power at all. If I put it on the base to charge, Home button lights up green, tells me to turn the switch on (it’s already turned on, but I press ok anyways). Home button turns to amber (slow blink to indicate charging has started). After between 10-30 seconds, it changes to rapid amber blinking on home button and after about 3 seconds it shuts down, reboots and starts the process all over. Ideas?

⟐ Answered January 26, 2021 at 13:04 MST