iFixit - Active Questions With Device "Maytag Washing Machine"

Maytag Washing Machine: du/dl error: replaced lid lock no change

Wed, 01 Apr 2026 01:17:53 -0700

MAYTAG BRAVOS 400 SERIES MVWB800VQ0

Replaced Lid Lock W10059230 with Maytag recommended replacement W10619844 lid lock. No change in error code of DL/DU, DU specifically.

I dismounted the new lock and left it outside the enclosure where it was observable and while the old lock reacts and attempts to lock, the new lock does not react at all.

Any ideas?

⟐ Answer edited April 01, 2026 at 1:17 MST

Maytag Washing Machine: The stator on washing machine motor 1/2hp has some uneven spacing

Mon, 23 Mar 2026 14:48:39 -0700

It's a new motor. I noticed the uneven spacing and the yellow mark while pulling motor out of the box. It has a T shape marking from the factory. Hopefully means: "Tested". Anyone knows what that means? Also some o the cardboard got stack on the lamination on one corner due to rough handling. I tried to brush if off buy it's stuck. I am guessing that's not a problem since there are stickers on the stator anyway... Thanks

⟐ Commented March 23, 2026 at 14:48 MST

Maytag Washer MVWB765W: Washer will not fill with water

Fri, 13 Mar 2026 15:43:47 -0700

Will not fill with water. No valve blockage and electric valves open and close when bench tested. Control board was tested and it too is not the problem.

⟐ Commented March 13, 2026 at 15:43 MST

Maytag Bravos quiet series 300: Why does it take so long for my Maytag to wash clothes?

Wed, 25 Feb 2026 19:32:15 -0700

The "Normal" cycle is :41 minutes total...or so it says. But, it takes 1:10 minutes to wash!! Why??

⟐ Commented February 25, 2026 at 19:32 MST

Maytag Washer MVWB765W: Lid switch malfunction, how can I bypass this switch

Tue, 24 Feb 2026 09:09:50 -0700

I have a lid switch malfunction ,how can I bypass this switch

Maytag Washing Machine: What is the proper belt tension on a MHN33PDCWW0?

Fri, 20 Feb 2026 01:48:55 -0700

We have 6 MHN33PDCWW0 front loaders in our RV park that are

Over 11 years old. Some are having problems with unbalanced loads and go into "suds" and shuts down during the last 5 minute spin. At 8 minutes, if it can't correct the unbalance by 5 minutes it will shut down. Could it be worn loose belts that are over 10 years old? What is the proper belt tension?

Sometimes the load won't come up to speed and sometimes won't drain, leaving water in the drum, so I have to put it in 6 08 then P06 to manually spin.

⟐ Answer edited February 20, 2026 at 1:48 MST

Maytag Washing Machine: Having trouble removing the main top panel of Maytag washer

Sun, 15 Feb 2026 12:19:55 -0700

Having trouble removing the main top panel of Maytag washer MVW7232HWO. I removed the 3 screws in the back of the washer and then tried to lift and pull the main panel forward without success. It will not budge. Please help

⟐ Commented February 15, 2026 at 12:19 MST

Maytag Washing Machine: Washer is so loud while spinning out the clothes

Wed, 11 Feb 2026 03:39:03 -0700

My Maytag MVW7230HC washer is a few years old and it just started getting very loud while spinning out. No shaking or banging sounds

Which part is causing the noise?

⟐ Edited February 11, 2026 at 3:39 MST

Maytag Washing Machine: غسالة تاخد الماء تم تصرفه في نفس الوقت

Tue, 10 Feb 2026 00:47:46 -0700

غسالة تاخد الماء تم تصرفه في نفس الوقت

The washing machine takes in water and drains it simultaneously.

⟐ Commented February 10, 2026 at 0:47 MST

Maytag Washing Machine: Model mvwc555dw0 won't agitate but runs rest of cycles

Sat, 07 Feb 2026 07:47:01 -0700

Washer will fill up with water, drain, spin but it in wash cycle it just sits still and does nothing. I've replaced the plastic gears and belt once before. There is still a loud grinding noise like the gears are grinding together. That's reason why I replaced the gears before. Idk what to do I've researched for 3 days and found possible problems but I'm limited on income and don't wanna buy wrong part. I'm at my last end with this crap. Please someone help me out and point me in the direction I need to go please

⟐ Answered February 07, 2026 at 7:47 MST

Maytag Washer MVWB765W: Why my washer not powering on?

Tue, 03 Feb 2026 15:26:19 -0700

My Maytag washer not powering on. I checked the power outlet and it is working fine. I changed the electric control board and still it’s not working. What could be my plan of action ? How to check if my display panel working ?

⟐ Commented February 03, 2026 at 15:26 MST

Maytag Washer MVWB765W: top bearing in washer tub came apart

Sun, 01 Feb 2026 10:48:14 -0700

The top bearing came apart and the ball bearings fell out. How do I get the bearing out not that there is no ledge or flange to hit against?

⟐ Commented February 01, 2026 at 10:48 MST

Maytag Washing Machine: Why is my washer loud on spin cycle.

Mon, 26 Jan 2026 14:00:50 -0700

My Maytag MVW6230HW2 washer is making a very loud noise during the spin cycle. It’s not out of balance or unlevel

⟐ Commented January 26, 2026 at 14:00 MST

Maytag Washing Machine: Two year old Maytag MVW4505MW

Mon, 19 Jan 2026 08:30:21 -0700

LED lights are not staying lit. Tried unplugging and plugging back in. Only "Lid Lock" light illuminates then goes out. The white lights to the left give a brief flicker then do not illuminate again. Same results after several unplugs. I am not certain if it will require a new circuit board or the individual electrical junctions at the three knobs. Any suggestions. (I cannot get trouble codes because the LEDs are not staying lit).

⟐ Commented January 19, 2026 at 8:30 MST

Maytag Washing Machine: Need help, the pulsing sound is a grinding sound

Sun, 18 Jan 2026 08:18:30 -0700

When trying to run a load the normal pulsing sound, and I know I should upload a video but am bedbound today, it is an extremely loud grinding sound pulse, ordered a clutch kit and I hope that is what it is. Any help folks???

Maytag Washing Machine: new maytag washer question

Sun, 11 Jan 2026 06:32:46 -0700

we got this maytag washer and drier new this past june. and started to use it in sept when they let us in our new house and installed it.

i have a few questions?

1. why does it use hot water when we select cold wash and cold rinse?

2. why can't i get custom cycle to work?

3. why can't i get the fill level to change. at normal the cloths do not get fully wet until they start to spin out, and if we try the different levels only deep fill works and then that is really to much water?

4.when i turned off the hot water then the softener bowl never empties. so it seems it is not doing the softener?

so what might i be doing wrong? this should not be rocket science.

thanks

⟐ Answered January 11, 2026 at 6:32 MST

Maytag bravos xl: Washer shuts off during spin cycle, no error code. Will start back up

Mon, 05 Jan 2026 19:08:43 -0700

Washer shuts off at spin cycle, no error code. Drains when turned back on

⟐ Answered January 05, 2026 at 19:08 MST

Maytag Atlantis MAV9750AWW: Skipping drain and rinse

Sat, 03 Jan 2026 13:33:58 -0700

My Maytag Atlantis seems to work fine except it skips drain and rinse.. but drain and rinse works perfectly besides..

I’ll put a load in, set the cycle and it goes through whole cycle and I come down and it’s finished, but the tub is still full of water.. I reset dial to spin cycle, it immediately empties and spins.

why? How is it skipping? What’s not clicking in to tell it to actually do the spin? Mechanically the machine doesn’t seem to have any problems to do the drain and spin.

⟐ Commented January 03, 2026 at 13:33 MST

Maytag Bravos quiet series 300: Machine tries staring but stops mad code F51 shows up

Sun, 21 Dec 2025 23:33:21 -0700

What does F51 mean on the display?

⟐ Answered December 21, 2025 at 23:33 MST

Maytag Washing Machine: Why does my washer sound like it’s about to take off when spinning?

Sun, 21 Dec 2025 05:30:42 -0700

My Maytag mvw7232hw0 washing machine is very loud when spinning. It’s not unbalanced and it works great, except for the loud noise.

Is there any way I can fix it?

⟐ Answered December 21, 2025 at 5:30 MST