<![CDATA[iFixit - Answers With Device "MVWC465HW3"]]> https://www.ifixit.com/Answers/Device/MVWC465HW3?rss=yes en-US Tue, 14 Apr 2026 06:46:43 -0700 <![CDATA[MVWC465HW3: Washer stopped mid wash and won't turn back on.]]> My Maytag washer stopped during a load before it was supposed to drain and finish. Now when I try to run it, it will fill for a second or two, stop, and the sensing fill light will flash. My washer will not enter diagnostic mode, so I took some of it apart to troubleshoot before replacing parts. I checked inlet valves (not clogged), drain valve (as soon as it was disconnected, water flowed out, so not clogged), all parts in the control panel were clean and connected properly. I did research and replaced the part W10285511 for the water sensor, thinking that was the problem. Nope. I did more research and chose to order a new lid lock component. It's almost here and I will replace it then. If that doesn't work, I'm not sure the next steps. I really dont want to call out a tech. Any advice?

⟐ Commented September 12, 2025 at 23:24 MST

]]> https://www.ifixit.com/Answers/View/916317/Washer+stopped+mid+wash+and+won't+turn+back+on. https://www.ifixit.com/Answers/View/916317 Fri, 12 Sep 2025 23:24:57 -0700