I confirmed that the heating element resistance is correct, then soldered a spade terminal onto the wire to verify that it works (it does). I'd now like to make a permanent fix.

The part that is corroded is a small connector with a ceramic base and two spade terminals. The part is easily removed, but isn't identified separately on the parts diagram. Rather it's part of the pump case assembly (Part #ABT72989202). On this dishwasher the heater element cannot be replaced separately from the ($200-$300) pump case assembly.

Since the heater element works, I'd like to replace the electrical connector.

The body of the connector as shown below is 17mm wide, and there should be a spade terminal coming off to the left and right from the main body.

On the back side, I found the following numbers that may or may not be part numbers. I've had no luck finding the part online.

155 131 003
23       16
260C

Any help identifying this part and a place where I can buy it would be appreciated. Thank you!

⟐ Answer edited December 20, 2024 at 13:16 MST

⟐ Commented November 07, 2024 at 1:57 MST