⟐ Answered September 20, 2024 at 22:50 MST

I'm trying to replace my motor control board but 1 of the 3 wires is stuck. The other 2 wires had a clamp but the blue wire does not have any clamp and it's stuck. I used players, i wiggled the part loose a bit and the connection still will not release. I'm trying not to damage this wiring part as it will cause another issue. How can I disconnect the blue wire from the old motor control board with out damaging it so I can connect the washer with the new replacement part?

⟐ Answered September 29, 2025 at 18:03 MST

⟐ Commented May 15, 2025 at 8:22 MST

⟐ Edited July 18, 2025 at 1:16 MST

⟐ Answer accepted November 23, 2025 at 9:48 MST

My Electrolux Washing machine (model # EIFLW50LIW0) is making a loud banging sound at the end of the spin cycle (and the noises during rest of the cycle, while close to normal, just don't seem quite 'right' to me...but that could be just me overthinking it). Checked the belt, looks fine, still tight, showing little wear, almost new looking still. Drum spins freely, not binding on anything. Shock absorbers seem to all work smoothly as well, though I do notice the drum does tilt backwards at the top, so almost looks the top of the drum could come in contact with the rear cover when it's on (though doesn't seem to be any obvious scrapes/wear on the inside of the cover). Not sure if it's normal for the drum to tilt backwards like this when at rest, or if possible the rear shocks have lost some of their strength? Or if it's another problem altogether, a drum bearing or something.

Thanks in advance for any advice.

⟐ Commented July 23, 2025 at 5:58 MST

⟐ Commented October 05, 2025 at 12:17 MST

The Maschine was not able to spin up to his 1400 rpm. I check pump, bearing and suspension. Find a little slak in bearing and bad suspension. Change everything, clean and check pump, but the problem is exactly the same. Get into troubleshooting menu, test everything, all is okay. In spin modus the trumble gets 1370 rpm. Delete fault measages and tru again. Same problem.

Feels like the machine wobble more in spinning mode, also when it is empty.. And when it start wobble it gives up spinning and reverse for a new try. In troubleshooting menu there is no kind of wobble.

Can someone give me a hint here?

Google English translation:

Title: I can no longer close the door of my washing machine

Description: The door of my washing machine no longer closes

⟐ Edited September 16, 2024 at 21:38 MST

EWF14933 is the model that I have.

⟐ Edited by author April 02, 2024 at 19:22 MST

⟐ Edited by author July 29, 2023 at 17:35 MST