So, next I took the main body to pieces to reveal the PCB. Using my multimeter I found there was 21V across the vacuum motor terminals. But when I went across the brush head supply terminals I get nothing. However if I go on the positive terminal of the brush head and the negative of the vacuum motor I get 21V.

i’m aware that there is some sort of overload to protect the brush head motor in the case of drawing high currents, and im assuming it’s in the negative line, but where is it? And can I reset or replace?

⟐ Commented May 18, 2026 at 9:42 MST

⟐ Edited by author February 13, 2026 at 7:51 MST

⟐ Commented January 25, 2026 at 11:57 MST

⟐ Answered December 02, 2025 at 12:17 MST

At first when I put Bumblebee ( I named her after Transformers) on the charger the light came on and the vacuum went vrrm for a second before dying , than after that nothing just a click , now just silence and no light .. reminiscent of old car in the winter when the starter or alternator go out . I d like to know if there is a way to know which the problem is and if it's something I can myself fix and or replace.

⟐ Commented October 15, 2025 at 0:47 MST

I’ve uploaded 2 pictures. 1st picture is my broken motor with the plastic part that I haven’t deattached yet. The other picture corresponds to another dyson v6 fluffy brush motor fullydisassembled

Upper line numbers: 1030986

Lower line numbers: 9S0231 C3

⟐ Commented September 08, 2025 at 9:36 MST

⟐ Commented July 06, 2025 at 1:43 MST

First let me say, the battery charges just fine and I’ve totally cleaned out the collection bin. I push the button to turn on the vacuum and it works, but then turns off and on over and over again while I’m still holding the button down.

I looked this up online and someone said the filter needed to be cleaned. So I took out the filter rinsed it as the online instructions said, let it dry, then put it back in. This did not solve the problem.

Any other suggestions?

⟐ Answer edited June 20, 2025 at 10:00 MST

It properly charged during its last charge but will not function. My instinct tells me this may be a battery issue as I'm sure it's reached its maximum charge/disbursement lifetime.

I also notice that if I plug it in to charge now, I get the same flashing red light. It has not been dropped or anything else.

Is a battery the correct component I should be eyeballing?

Many thanks!

Kim K.

⟐ Commented November 11, 2024 at 0:24 MST

⟐ Commented July 01, 2024 at 20:34 MST

⟐ Commented March 15, 2024 at 7:31 MST

⟐ Answered December 24, 2023 at 14:02 MST

After a full charge, motor kicks out after 2 minutes of operation- put on charge again for one minute- motor starts again for an other minute- put on charge few more minutes- vacuum cleaner OK for ONE minute; and so forth. Could the life of battery has ended?

Note: on the body, the light is solid blue when in operation and flashing every time the cleaner stops.

⟐ Answered October 20, 2023 at 11:02 MST

It's detached the ends.

I can't find a suitable screw.

Can anyone help me?

Please refer to the picture below.

http://imgur.com/t33SicS

http://imgur.com/4buEhgq

Wand info is below.

https://www.amazon.com/gp/product/B018BJ...

⟐ Answered July 24, 2023 at 11:40 MST