iFixit - Answers With Device "Dremel MultiPro 395"

Dremel MultiPro 395: Why is my Device not turning on?

Fri, 17 Oct 2014 09:50:00 -0700

I plugged My MultiPro in and no matter what I do it will not turn on. The bit will not rotate and the device seems to not be getting power at all. Can this be fixed?

⟐ Answered October 17, 2014 at 9:50 MST

Dremel MultiPro 395: Why is my device running at inconsistent speeds?

Thu, 13 Apr 2023 06:24:04 -0700

I plugged my device in and it will either turn on and run super fast or super slow and nowhere in the middle. How can I go about fixing this problem?

⟐ Commented April 13, 2023 at 6:24 MST

Dremel MultiPro 395: Will somewhat run if the brush caps are squeezed together, how to fix?

Sat, 08 Jul 2023 12:59:23 -0700

So my multi-pro only runs intermittently if I squeeze the brush caps together, how do I fix this? Do the brushes need to be replaced? What do I need to check?

⟐ Commented July 08, 2023 at 12:59 MST

Dremel MultiPro 395: Dremel 3000 will only work when pressing side lid

Wed, 14 Sep 2022 22:56:20 -0700

Hello!

We have a dremel 3000, which is similar to the Multipro 395 because both have a plastic lid with an inner thread that pushes a copper coil.

Our lid is loose and thus, the coil does not make proper contact with the metal piece inside. When we push with a finger it works well. Any idea on how to fix that ?

I think this is a similar problem and this a solution, right?
However, they do not specify how to dissasembly to Dremel, any help?

We opened it and found out that a metal piece had broken

We added a small metal piece to ensure contact is made and it works!

⟐ Edited by author September 14, 2022 at 22:56 MST

Dremel MultiPro 395: The shaft won’t turn

Wed, 14 Oct 2020 18:05:07 -0700

Shaft won’t turn on deemed model 395

⟐ Answer accepted October 14, 2020 at 18:05 MST

Dremel MultiPro 395: My main drive shaft faulty

Sat, 26 Sep 2020 15:42:11 -0700

I replaced my dremals 395 plastic coupler and the chuck spins but if I grab it with my finger I can stop it but the motor is still running.

Dremel MultiPro 395: Is switch bad on dremel 395

Fri, 29 Jan 2016 16:46:06 -0700

On dremel switch there are 4 connector prongs how many should have power when switch is on