iFixit - Answers With Device "Chrysler"

2001-2007 Chrysler Voyager: ما هي مشاكل ( abs) td hg;vd.gv 2005?

Thu, 26 Mar 2026 21:54:14 -0700

ما هي مشكلة (abs) علما بانه لا يوجد انقطاع في الأسلاك لكن إضاة مؤشر مستمرة والفرامل تعمل المشكلة الأضاء مستمرة وكذلك مانع النزلاق

⟐ Commented March 26, 2026 at 21:54 MST

2008-2016 Chrysler Town and Country: Why is my engine light on

Thu, 26 Mar 2026 11:42:58 -0700

My engine light is on, I think it has to do with air

⟐ Answered March 26, 2026 at 11:42 MST

2005-2010 Chrysler 300: My car won't get to higher rpms just backfires spits and sputters

Wed, 25 Mar 2026 07:17:36 -0700

My car won't reach higher rpms pumping it hold it to the floor just backfires spits and sputters or dies

⟐ Answered March 25, 2026 at 7:17 MST

Chrysler PT Cruiser: How to deactivate antitheft system

Fri, 13 Mar 2026 02:26:23 -0700

Car won't start antitheft light came on

Chrysler Crossfire: Battery won't keep a charge

Sun, 08 Mar 2026 21:08:06 -0700

I can put a new battery on it and it will be fine but if I leave the car parked for awhile the battery will go dead.

⟐ Answer edited March 08, 2026 at 21:08 MST

Chrysler PT Cruiser: The easiest way to remove my radiator on my 02 pt cruiser

Fri, 27 Feb 2026 18:22:10 -0700

The easiest way to remove the radiator on my 02 pt cruiser

⟐ Answered February 27, 2026 at 18:22 MST

2011-Present Chrysler 300: Where can my coolant be pouring from

Tue, 24 Feb 2026 14:31:27 -0700

Does anyone know why my 3.6 300 can be pouring water near the back of the lower intake manifold even without the engine running

⟐ Answered February 24, 2026 at 14:31 MST

2008-2016 Chrysler Town and Country: Why is my oil pressure sensor reading high

Thu, 05 Feb 2026 20:15:36 -0700

Engine light went on then finally shut off saying the oil pressure sensor was high

⟐ Answered February 05, 2026 at 20:15 MST

2008-2016 Chrysler Town and Country: In my Chrysler 2008 Town anIt's 2025 and now my key will not come out.

Sun, 01 Feb 2026 10:49:55 -0700

Last week I replaced the starter which had gone out. Now my key will not come out of the ignition unless I pull that 10 amp fuse under the hood. Additionally I'm having trouble putting it in park. I have to up and down the shifter several times to get it to go into Park. Can anyone help me with this problem.

⟐ Commented February 01, 2026 at 10:49 MST

2005-2010 Chrysler 300: Putting headunit in with no wiring diagram

Thu, 22 Jan 2026 18:27:08 -0700

The car came with some terrible cheap android sound system.. that didn't work.. and wires cut and left hanging. Im trying to fix this. But it seems like i can't figure it out.

⟐ Commented January 22, 2026 at 18:27 MST

2008-2016 Chrysler Town and Country: Starting/power issues, new battery, starter is fine

Wed, 21 Jan 2026 14:28:52 -0700

My 2011 chrysler town and country van has been acting weird lately. My wife said it wouldn't start one morning so I bought a new battery, as the old one was over 6 years old. Come to find out, it does nothing when trying to start with the new battery. The odometer comes on when opening the door but that is all. Turn the key, nothing. Now the weird thing: I unhooked the battery and put the terminals together for an hour or so. Hooked up the battery again and it started right up. Shut it off and let it sit. Turned it on a bit later to pull it out of the garage and shut it off in driveway. Went back a few hours later only to find it would do nothing again. I've since had it start again after disconnecting the battery for awhile only to do nothing the second time I try to start it. I've read somewhere it could be a bad bcm? But why would it keep starting after being disconnected from power for awhile? Please help!

2011-Present Chrysler 300: Why do I have a rough idle, but runs great

Fri, 23 Jan 2026 01:19:55 -0700

Why does my radio jump from station to station

⟐ Answer edited January 23, 2026 at 1:19 MST

2005-2010 Chrysler 300: "No Communications" with the ECM

Fri, 16 Jan 2026 23:02:43 -0700

My background: Former Chrysler technician, 17 year employee @ Alldata.com as Senior Technical Editor, ASE certified Master Tech (plus numerous other certs)

Vehicle: 1971 Plymouth Barracuda

Engine: 2006 Chrysler 300 6.1 Hemi with original engine harness, ECM, & FCM Transmission: Tremec 6 speed manual

200 PSI compression pressure while cranking.

The ECM has had the SKIM (security) option deleted by All Computer Resources, Inc.

I have triple-checked powers, grounds, 5 volt references, and wiring to both modules. Also has 12 volts & 2 grounds at the OBD connector.

The CAN high & low wires measure 60.8 ohms. Voltages on those lines measures 2.61 volts and 2.43 volts, respectively.

Crankshaft Position Sensor and Camshaft Position Sensor are making their respective outputs, as measured by an external oscilloscope.

The ASD Relay & Fuel Pump Relay do power up when the key is turned on, then the fuel pump relay waits for a cranking signal, then it re-energizes when the engine is cranking.

Has power to the coils & fuel injectors through the ASD relay.

Problems:

When I plug in the scan tool, it powers up but can't communicate with the ECM.
No spark output at the coils
No fuel injector pulses.

Any ideas for correcting the “No Communications” problem would be greatly appreciated.

According to Chrysler, the Front Control Module (FCM) acts as global communicator for all of the other modules. Does anyone know of a way to bench test the FCM?

Someone else suggested trying another ECM, in case this one is bad. Sure, it could be bad. I'm not sure if it was working before the SKIM delete was performed or maybe it went bad BECAUSE that was performed. I thought about plugging this ECM into another car, just to see if it would communicate, but according to Chrysler, doing that would reactivate the SKIM system, thus negating the $125 SKIM delete that I've already paid for.

⟐ Commented January 16, 2026 at 23:02 MST

2008-2016 Chrysler Town and Country: Cant find an antifreeze leak

Mon, 12 Jan 2026 19:07:12 -0700

I removed the Radiator then put it back together, replaced the thermostat and now there is a leak that i can't nt seem to find

2011-Present Chrysler 200: How to replace the thermostat?

Sun, 11 Jan 2026 10:23:01 -0700

Have an issue with thermostat, I'd like instructions how to replace it

⟐ Commented January 11, 2026 at 10:23 MST

2001-2007 Chrysler Voyager: The car is sputtering and typing a lot cruise

Sat, 10 Jan 2026 12:23:16 -0700

The car is sputtering and typing a lot Cruise

2011-Present Chrysler 300: How do I replace the engine myself?

Fri, 09 Jan 2026 09:13:25 -0700

How do I replace the engine myself?

⟐ Answered January 09, 2026 at 9:13 MST

Chrysler Crossfire: ABS ESP light turns on and off

Thu, 01 Jan 2026 17:45:33 -0700

My ABS ESP light comes on when I step on the brake pedal and my brake lights won't work but randomly the ABS ESP light doesn't come on and my brake lights do work. what can I do to solve this issue?

⟐ Commented January 01, 2026 at 17:45 MST

Chrysler Town and Country: 2015 Chrysler town and country 3.6 fuel tank wiring diagram

Sun, 21 Dec 2025 01:01:19 -0700

Does any one have the fuel tank wiring digram for 2015 Chrysler a town and country

⟐ Answered December 21, 2025 at 1:01 MST

Chrysler 300: 2006 Chrysler 300 Limited Parasitic Battery Drain?

Sun, 14 Dec 2025 15:37:51 -0700

With ignition off the car drains nearly 2 amps. I have tested all fuses and relays, front and rear electrical boxes, with only minor change, except for fuse #1 (Ignition Off Draw) in the rear box. By pulling that fuse the drain is stopped but the security system, power locks including trunk latch, radio/entertainment system, dash compass, and perhaps more, are disabled. Other than these, all systems seem to work with fuse #1 disconnected. Has anyone had any experience with this type of electrical issue? Thanks