my Revolve+ doesn't charge anymore, even though there was no damage. I just haven't used it for years. What can I do?

Thanks

⟐ Commented May 15, 2026 at 12:23 MST

⟐ Commented May 02, 2026 at 11:31 MST

⟐ Answered April 02, 2026 at 10:39 MST

Does anyone know if the batteries offered on IFixit are interchangeable with the 061384?

TIA

⟐ Commented March 31, 2026 at 20:31 MST

⟐ Answered March 20, 2026 at 13:03 MST

a. Charges normally, blinking yellow till charged then constant green

b. Does not charge, blinks yellow, I press power it and stays at same charge level

c. Charges to a level (like 70%) and stops there (until powered off /on)

d. Usually I could just run it until it totally died from a dead battery and then it would charge to 100%

The LED light would always turn off during use (unless it was being charged or was totally run-down to the red mode). Regardless, I could use it, but I was hoping for a firmware fix.

---------------------------

All these scenarios stopped when I recently (2026) found there was a new firmware update and I updated it (to version xxx.14). Now it ALWAYS shows the yellow LED except for a momentary green after unplugging the charger. It has never again done the #a or #d scenario again, but it seems to fully charge because when you disconnect the charging (quick green flash and the yellow led stays on) it runs the battery down to zero pretty quickly (1 night of use maybe 1-1/2). I am going to be shipping it in (buying a replacement), but it would be nice if they would have fixed it.

This "question" is just for anyone that still has the speaker and sees issues or anyone that manages to permanently fix it. Otherwise, my advise is DONT update it to version xxxxx.14

So my question is will you please post a reply to this thread what you did to fix it (user), or what you could have done or will do to fix it (Bose)? I think it is a firmware issue (bug). The speaker still works good.

When I connect the power cable, the power indicator blinking red always, and device can not be turn on.

What's the problem? Who can help me to solve it?

⟐ Commented January 25, 2026 at 9:55 MST

⟐ Commented January 14, 2026 at 12:26 MST

Hi All,

Can you please help me the exact values of these capacitors and the 2 missing, It's hard to check since there are no Component Labelling in the Mainboard.

Thank you

⟐ Commented January 13, 2026 at 9:21 MST

I tried resetting it by pressing the mute button for 10 seconds but this did not help.

The manual doesn't have advice for this specific problem.

⟐ Answered December 30, 2025 at 21:06 MST

⟐ Commented December 26, 2025 at 11:37 MST

⟐ Commented December 01, 2025 at 21:15 MST

I want to make sure I connect everything correctly without causing a short circuit or damaging the board. The color codes don’t match, and I’m not sure which wire corresponds to which function (power, ground, thermistor, data, etc.).

Any guidance or wiring diagram for this model would really help. I have a multimeter and can take resistance or voltage readings if needed.

There’s no videos on the internet doing it step by step. Just how to split it open.

I welded that way and the led started flashing rapidly @oldturkey03

⟐ Commented October 31, 2025 at 16:42 MST

Now after 24 hours of charging, it doesnt switch on.

once i turn on the charger, these 3 white lights on my speaker turn on for a second and turn off.

after that it indicates red light even when the charger is turned on.

⟐ Commented October 26, 2025 at 10:46 MST

Any idea, what to check if just the LEDs are the problem? Any loosen connector?

It happens just between two days of normal usage :-/

Making a "factory reset" did not solve the problem.

⟐ Answer accepted October 16, 2025 at 12:42 MST

Battery tests good.

The speaker doesn't power on.

⟐ Answered October 16, 2025 at 3:21 MST

⟐ Commented September 26, 2025 at 18:51 MST