⟐ Commented November 01, 2025 at 15:43 MST

This is all I have

⟐ Commented July 17, 2024 at 18:02 MST

I can hear the fan when the door is closed. Compressor is hot to touch (almost too hot to touch). If I feel the condenser coils on the back of the fridge they aren't hot at all at top or on the rhs or anything. So it feels like the condenser is working hard, but not a lot else happening maybe ?

⟐ Answer accepted March 09, 2024 at 7:56 MST

⟐ Commented July 25, 2025 at 21:38 MST

I purchased a new Bosch fridge freezer and it is around 1 week old. Within the first day of turning it on there has been a build up of a thin layer of frost on the interior back wall (just in the middle, never at the top or bottom). Sometimes it melts and leaves droplets of water and then sometimes it becomes ice. This occurs every day.

I had a Bosch engineer look at it but they claimed that this is normal and all fridges work in this way today. But I'm a bit skeptical.

Any advice would be appreciated. Thank you

⟐ Answered August 18, 2023 at 15:49 MST

The LED light and the on/off button aren't working in my Bosch refrigerator and I need to replace the Dispenser ice door support, part # 00654154. The part includes the LED light ring and is being ordered. What is the best way to remove the freezer control panel?

⟐ Edited March 18, 2024 at 10:30 MST

⟐ Commented January 09, 2026 at 6:56 MST

This is the picture of the water tanks. the white tube is connected to the valve at the back of the fridge. The grey tube is what I have problem to locate how to disconnect from fridge.

⟐ Commented December 19, 2025 at 21:34 MST

⟐ Answered October 12, 2025 at 7:36 MST

I recently checked all the refrigerator components (PTC relay, start capacitors, pump windings, thermistor response (2 off), and some control board component (capacitors, triac, diode), but couldn't find any signifiant fault (I did change the 4uF start capacitor as it had dropped to 2.9uF (no difference) and re-soldered one iffy joint (no difference)

By chance I found the pump would run and cool if I disconnected the two NTC thermistors (thermostats) with a starting wattage of about 60W quickly dropping to about 40W, as the start relay cut out.

But after exactly (to 10 secs) and reproducibly 15 mins, the pump stopped again. Then it started again exactly 45min later and so continued in this safe mode at about +3C, I guess to protect the fridge contents. Do other fridges have this feature? why are there two thermistors? could I use a universal fridge thermistor?

This is not a long term solution as the fridge will need a longer cooling time in summer or in heavy use and the only manual over-ride is to turn the fridge off and on again when it stops cooling to restart the cycle. (you can't change the on/off ratio by adjusting the temperature on the front panel)

Any ideas what else I can do, given that most of the parts are obsolete and no service manual is available online.

⟐ Commented January 22, 2025 at 9:33 MST

⟐ Edited December 18, 2023 at 15:01 MST

⟐ Edited December 18, 2023 at 15:01 MST

So I've no idea what this code means, Google isn't helping me and Bosch have been particularly unhelpful by not telling us what it means just that it needs and engineer.

Does anyone have any idea what the E 47 code means in Bosch Fridge Freezer speak?

Thanks in advance

Claire

⟐ Edited December 27, 2023 at 15:06 MST

⟐ Commented January 09, 2026 at 21:43 MST

⟐ Commented December 06, 2025 at 8:03 MST

⟐ Commented December 02, 2025 at 2:27 MST

I now know how to get into service mode, but don't know the codes/procedures. Does anyone have the service manual for this model?