iFixit - Answers With Device "Alpha Hover-1"

Alpha Hover-1: E1 error after motor cable replacement

Mon, 14 Jul 2025 17:11:36 -0700

Motor cable was ripped off from a crash. When I went to replace the cable I noticed a white wire floating around inside the hub. Did some research and found out that wire is for temperature sensor. I looked all over the Hall Sensors circuit board and couldn't find a place to solder the white wire to. I also noticed an extra end point from the motors cooper coils. I connected the 3 phase wires to each coils end points but there's a 4th cooper coils end point. Is 4 coil endpoints normal and is the 4th point for the white wire because that's the only place I can think of that looks like the wire can connect to. It's also a thin white wire and the phase wires are much thicker so I left the 4th coil alone and attempted to solder the white wire to the positive pin on the last hall Sensor. That didn't work. Scooter turns on normal and E1 code pops up soon as the motor turns

Alpha Hover-1: Hover-1 Alpha not turning on

Sat, 17 May 2025 16:01:46 -0700

When I am trying to turn I am getting sound from speaker, but the scooter is not getting turned on. No beep sound for scooter on and nothing comes in display. Only getting one beep sound from speaker and the red light got on. When I released the power button, the red light also turned off.

Can anyone help me

Hover-1 alpha

Alpha Hover-1: Not working right. It goes then nothing then goes then nothing. The ba

Thu, 13 Feb 2025 02:33:24 -0700

The battery is charged maybe it's the motor?

Alpha Hover-1: My scooter goes into limp mode

Sat, 28 Dec 2024 07:35:29 -0700

I don’t know exactly what’s happening, but after riding for a little bit, maybe 5-10 minutes, my scooter seems to go into a sort of limp mode and won’t go faster than 6 mph. Going up hill I have to push and it will only go 2 or 3. It’s like it’s reducing power output by 70% or so. Any thoughts?

Alpha Hover-1: How to remove/reinstall the rear tire on a Hover-1 Alpha folding scoot

Sat, 30 Nov 2024 16:42:01 -0700

The alpha has a motoring the rear wheel. Repairing a flat in the back tire is a ridiculously difficult task. Reassembley instructions would be very helpful.

⟐ Commented November 30, 2024 at 16:42 MST

Alpha Hover-1: Can I use a charger other than the original one

Mon, 30 Sep 2024 15:23:05 -0700

Can I use a Jetson switching power supply

Model# FY0422941200

Input #100-240V - 50/60Hz 1.5A

Output # 29.4V - 1.2

Instead of the original hover 1 charger that comes with the scooter

Alpha Hover-1: Where can I get a replacement folding latch

Wed, 13 Sep 2023 09:43:15 -0700

My folding latch that is on the front of the steering shaft broke, but I cant find a replacement piece for it anywhere, where do I go to get a new one, or what trouble shooting replacement can I make

⟐ Commented September 13, 2023 at 9:43 MST

Alpha Hover-1: Popping noise from speaker

Sun, 02 Apr 2023 22:37:50 -0700

After powering the scooter on there is a popping noise coming from the speaker every 5 seconds. Everything else works fine except for this unusual popping noise coming from the speaker every 5 seconds. Any ideas?

Alpha Hover-1: Front wheel not moving

Tue, 08 Nov 2022 16:06:54 -0700

Front drive motor won't work

I have power. headlight brakelight led display panel. Code c keeps appearing? Expensive fix?

Alpha Hover-1: throttle is stuck open wont stop running

Sun, 21 Aug 2022 19:21:38 -0700

I was riding and my throttle was stuck open I could not get it to shut down

Alpha Hover-1: How to replace front inner tube on alpha hover 1

Wed, 10 Aug 2022 18:33:44 -0700

How do I replace the front inner tube of my alpha hover 1

⟐ Answered August 10, 2022 at 18:33 MST