iFixit - Answers With Device "2011-Present Nissan Versa"

2011-Present Nissan Versa: Can I calibrate my fuel gauge to my new fuel pump?

Sun, 28 Jul 2019 12:43:11 -0700

Recently had my fuel pump replaced but the digital gauge on my dashboard doesn't sync up.

When the tank is full the gauge reads full. But after about 150 miles the gauge will read empty. If I keep going past the blinking empty gas tank warning , it will eventually read full again. After another 150 miles or so the gauge will show more than half a tank left but I will be left stranded on empty.

Is there a way to calibrate the gauge based on the new sending unit readings?

⟐ Answer accepted July 28, 2019 at 12:43 MST

2011-Present Nissan Versa: Why won’t my car turn over and start with clicking sound

Mon, 17 Nov 2025 03:17:53 -0700

Why won’t my car turn over ?

⟐ Answered November 17, 2025 at 3:17 MST

2011-Present Nissan Versa: How to repair/ replace driver side door

Fri, 03 Oct 2025 20:58:57 -0700

How to repair/replace driver side door and where to get door

⟐ Answered October 03, 2025 at 20:58 MST

2011-Present Nissan Versa: Car will not accelerate.

Sun, 12 Aug 2018 20:14:52 -0700

I went to start my car, I drove off with no issue. After a stop at the light, the car would not accelerate past 10 mph, with the rpm’s at 1.5.

⟐ Answered August 12, 2018 at 20:14 MST

2011-Present Nissan Versa: My nissan versa 2011 wear when I stop what happened?

Mon, 27 May 2024 20:49:27 -0700

The engine shake when stopping so far the muffler

⟐ Commented May 27, 2024 at 20:49 MST

2011-Present Nissan Versa: Transmission sensor leaking fluid

Sun, 04 Apr 2021 01:45:06 -0700

I scraped the bottom of my car on a curb. Now it is leaking transmission fluid from around some type of sensor that's right behind the tire on the driver's side. I need to know what the sensor is so I can have it replaced

⟐ Commented April 04, 2021 at 1:45 MST

2011-Present Nissan Versa: Hood prop rod replacement

Mon, 21 Sep 2020 18:49:13 -0700

My hood prop rod on my 2011 Nissan Versa broke and I purchased a replacement. How do I remove the old one off and install the new one?

2011-Present Nissan Versa: MAF sensor 2014 Nissan Versa

Thu, 04 Apr 2019 18:48:20 -0700

I have a code for the MAF sensor, low voltage to be exact. I’ve replaced the sensor but that didnt change anything. Does the car have to be reprogrammed after replacing the MAF filter?