So the sound only comes when the car is moving, it doesnt come on when the car is stop, when I accelerate and put the car in motion that's when the sound comes on and it doesnt go away until the car is stopped, (also when I dont give it gas but the car still in motion the sound still on,) I took it to a mechanic and not sure if he check it because he told me to drop it off and to come back a hour later, but he called me 20 minutes later and he told me that it might be the transmission but he wasn't sure, he told me to take the car to a transmission expert, and j have been asking around and just to check the transmission they are charging me 200+ just for the check up and for the record my car does all the changes good, no delay, or anything like that, so I when underneath my car and I was checking everything and notice that my drive shaft has some play when I move it, the car in in park, 

So I went online and found out that my u joints might be bad, or the drive shaft, not sure which one it is, I was also reading that the first sign that the u joints are going out it's when the car comes out of balance, and that happen around 3 months ago that I had to rebalance my tires and change 2 because they were worn out from the inside 

What's you guys opinion

⟐ Commented October 12, 2025 at 2:34 MST

⟐ Answered June 04, 2025 at 9:01 MST

would this be the idle speed motor perhaps?

⟐ Answered December 27, 2024 at 3:46 MST

⟐ Answer edited October 25, 2023 at 7:18 MST

⟐ Answered September 03, 2019 at 15:12 MST

⟐ Answered May 05, 2018 at 5:19 MST

⟐ Answered May 20, 2026 at 17:45 MST

⟐ Answered July 10, 2024 at 17:24 MST

⟐ Commented October 27, 2022 at 23:17 MST

⟐ Answered June 07, 2022 at 18:54 MST

I have noticed that when I turn on the AC, the acceleration power decreases a lot. Any idea why this happens?

Also, recently i noticed that i no longer get any Active Stability Control (ASC) display information on my information screen. I saw that warning when i was driving on a wet road but now my vehicle pulls a lot when i cut around bends.

Does anyone know why this has happened? Could it be that i need to get a sensor checked? Please advise.

No check light appears, have just recently scanned to look for error codes, no errors found.

Mileage is currently at 77k. Spark plug (NGK brand iridium single point) was changed at 54k.

Vehicle specs: Lancer 2013 GT, 4b11 engine, 2 litres. non-turbo. 2WD.

Have got the vehicle fully serviced. My engine bay setup is shown in the photo below

⟐ Commented May 19, 2021 at 21:21 MST

⟐ Answered April 09, 2021 at 7:20 MST

Model:Lancer;

Maker:Mitsubishi;

Year:2015;

Engine:2.0tdi

⟐ Edited May 21, 2019 at 5:06 MST

⟐ Commented October 06, 2025 at 7:20 MST

JA3AU26U39U612700

⟐ Edited June 12, 2025 at 8:23 MST

⟐ Edited by author April 15, 2025 at 20:33 MST

I must to open another door one by one，close is the same！

So after driving for about 10 minutes my 2015 Mitsubishi Lancer starts to sound like this and I’ve went to mechanics and they said they do not know what it is someone please help!

⟐ Commented July 07, 2022 at 7:08 MST